Philips Fidelio E6 - Using Your Product; Preparation Before Product Use; Adjusting Volume Levels; Surround Speaker Volume Control

17EN
Note
• Spatial calibration takes around three minutes.
• Surround sound improvement is only noticeable if the
wireless surround speakers were improperly placed, or
if there is strong surround effect in the music you play.
• If the wireless surround speakers are swapped in
placement, at the end of calibration L<->R is displayed
for few seconds, then the calibration completes.
• During calibration, you may press CALIBRATION
to cancel calibration, and the settings returns to the
default.
• If the spatial calibration fails, an error message is
displayed on the display panel, such as FAIL (fail), and
the settings returns to the default.
• If the spatial calibration fails, try the spatial calibration
again, and make sure that the calibration points
described at the beginning of this chapter are fully met.
6 Use your
product
This section helps you use this product to play
audio from connected devices.
Before you start
• Make the necessary connections described
in the quick start guide and the user
manual.
• Switch this product to the correct source
for other devices.
Adjust the volume
1 Press Volume +/- to increase or decrease a
volume level.
• To mute sound, press .
• To restore the sound, press again or
press Volume +/-.
For the wireless surround speakers only
1 When the wireless surround speakers
are wirelessly connected to the main unit
(in SOD mode), press to
increase or decrease a volume level.
Choose your sound
This section helps you choose the ideal sound
for your video or music.
Sound mode
Select predened sound modes to suit your
video or music.
• Press to create a surround listening
experience. Ideal for watching movie.
• Press to create two-channel or
multi-channel stereo. Ideal for listening to
music.