Philips FM20 - Page 24

2 What's New
24
Manually Entered Maternal Temperature Measurements
Manually measured temperatures can be entered at the fetal monitor. They are displayed as a numeric
on screen, and are printed out on the recorder trace (“Monitoring Maternal Temperature” on
page 249).
SpO2 Recordings and Transmissions
SpO
2
annotation on local recorder
You can now configure the interval for printing the SpO
2
numeric values on the recorder trace. With
the new configuration setting
Record on Trace, you can set the interval to 1 or 5 minutes.
SpO
2
transmission to an obstetrical information and surveillance system
You can now configure the interval for transmitting the SpO
2
numeric values to an obstetrical
information and surveillance system. With the new configuration setting
Send to OB Sys, you can set the
interval to 1 or 5 minutes.
New Design for the User Interface
The user interface for the fetal monitors has been redesigned to bring the presented information into
the foreground, letting the structural elements such as keys and frames retreat into the background.
Additionally special regard was given to making the "look and feel" similar to that of standard software
products (see “Operating and Navigating” on page 38).
New SmartKeys
•The Start ECG SmartKey and menu item is renamed to Record ECG.
•With the
Call Patient SmartKey, you can now page patients who are ambulating wearing Avalon CL
transducers.
•With the
Tele Info SmartKey, you can call up the Tele Info window on the fetal monitor display. In
the
Tele Info window, you can control and view the status of the cableless transducers from the
connected Avalon CL base station.
•With the
Enter Temp SmartKey, a pop-up window opens showing a numeric pad for entering
manually measured maternal temperature values.
•With the
NBP Modes SmartKey, you can access the NBP Mode selection and setup, and can directly
start and stop a measurement.
•With the
QuickAdmit SmartKey, you can quick admit a patient to the monitor.
All new SmartKeys are optional, and have to be configured in Configuration Mode for use (see
“SmartKeys” on page 42).
Coincidence INOP Tone
When the cross-channel verification detects that the signal of the maternal heart rate coincides with the
fetal heart rate, the
Coincidence INOP is now issued with a tone at the fetal monitor. The Coincidence
INOP tone has a configurable delay see “Cross-Channel Verification (CCV)” on page 159.