Philips FW-M567/22 - Programming the Disc Tracks; Checking the Programme; Clearing the Programme

20
English
Programming the disc tracks
Programming tracks is possible when playback is
stopped. Up to 99 tracks can be stored in the
memory in any order.
IMPORTANT!
It is only possible to programme from
the current selected disc tray.
D
I
S
C
1
D
ISC
1
D
I
S
C
2
D
I
SC
2
D
I
S
C
3
D
ISC
3
D
I
S
C
4
D
I
SC
4
D
I
S
C
D
ISC
3
D
I
S
C
D
ISC
4
D
I
S
C
D
IS
C
5
D
I
S
C
D
ISC
2
D
I
S
C
D
ISC
1
C
D
C
D
/
C
D
-
R
C
D
-R
/
C
D
-
R
W
C
D
-R
W
CO
M
P
CO
M
P
A
T
I
B
L
E
T
I
BL
E
D
IS
C
1
D
IS
C
1
2
4
6
7
3 5
,
1
1 Load the desired discs on the disc trays (refer
to “Loading discs”).
2 Press CD or one of the CD 1~5 buttons to
select a disc.
3 Press PROGRAM (PROG) to start
programming.
➜ PROG starts flashing.
4 Press í or ë repeatedly to select the
desired track.
● For MP3 disc, press à / á (ALBUM 43) and
í / ë (TITLE -+) to select the desired
album and title for programming.
5 Press PROGRAM (PROG) to store.
● Repeat steps 4–5 to select other tracks.
➜ If you attempt to programme more than 99
tracks, "PROGRAM FULL" is displayed.
6 To start programme play, press ÉÅ.
7 To stop playback or to end the programming,
press Ç once.
➜ PROG stays and the programme mode
remains active.
Disc Operations
Notes:
– If the total playing time reached 100 minutes or
if one of the programmed tracks has a number
greater than 30, then "-- : --" is displayed instead
of the total playing time.
– The system will exit programming mode if no
button is pressed within 20 seconds.
Checking the programme
1 Stop playback and press í or ë repeatedly.
2 Press Ç to exit.
OR
Press ÉÅ to start playback from the current
programmed track
Clearing the programme
● Stop playback, then press Ç to clear the
program.
OR
Press the OPEN•CLOSE 0 button of the
disc tray.
➜ PROG disappears and "PROGRAM CLEARED"
is displayed.
Note:
– The programme will be erased if the system is
disconnected from the power supply or you switch
to other source mode.