Philips FW-P75/25 - Sound Customization Options

14
English
3139 116 19761
OPERATING THE SYSTEM
Selecting the Equalizer
Display
You can select the desired equalizer display
for the system. You must not press the DSC
button on the system before using the JOG
control.
• Adjust the JOG control to select the
desired Equalizer Display, NORMAL,
TOP DOWN, or NITE MODE.
™ The selected display will be shown.
NORMAL Display
FRONT
FM
STEREO
BACK
HSD
REPEAT
REC
LW
MW
AM
T.A.NEWS
TIMER
60Hz
500Hz
250Hz
1KHz
2KHz
4KHz
8KHz
PROGRAM
TOP DOWN Display
FRONT
FM
STEREO
BACK
HSD
REPEAT
REC
LW
MW
AM
T.A.NEWS
TIMER
60Hz
500Hz
250Hz
1KHz
2KHz
4KHz
8KHz
PROGRAM
NITE MODE Display
60Hz
500Hz
250Hz
1KHz
2KHz
4KHz
8KHz
FRONT
FM
STEREO
BACK
HSD
REPEAT
REC
LW
MW
AM
T.A.NEWS
TIMER
PROGRAM
Note:
– In NITE MODE, all lights will be
switched off and the display brightness
will be dimmed.
Sound Control
VOLUME ADJUSTMENT
Adjust VOLUME to increase or decrease
the sound level.
For Personal Listening
Connect the headphones plug to the n
socket at the front of the system. The
speakers will be muted.
DIGITAL SOUND CONTROL (DSC)
The DSC feature enables you to adjust the
system to suit your type of music.
• Press DIGITAL SOUND CONTROL
(DSC) to select OPTIMAL, CLASSIC,
TECHNO, JAZZ, ROCK or VOCAL.
™ The selected digital sound is
encircled.
™ "OPTIMAL X, CLASSIC,
TECHNO X, JAZZ X,
ROCK X or VOCAL X" will be
displayed. "X" is the pre-selected
level.
With the JOG control, you can change the
level of any DSC setting except CLASSIC.
• First select the DSC feature, then adjust
the JOG control until the desired digital
sound setting level is reached.
™ The digital sound setting level will
increase or decrease between level 1
and 5.
Note:
– For neutral setting, select CLASSIC and
switch off DBB.
DYNAMIC BASS BOOST (DBB)
There are three DBB settings to enhance
the bass response.
• Press DBB briefly to select a bass boost
level.
™ The respective DBB level will be
encircled and lit.
™ "BEAT", "PUNCH" or "BLAST"
will be displayed.
To switch off DBB
• Press DBB briefly until "DBB OFF" is
displayed.
Note:
– Some CDs or tapes might be recorded in
high modulation, which causes a
distortion at high volume. If this occurs,
switch off DBB or reduce the volume.
Automatic DSC-DBB selection
The best DBB setting is generated
automatically for each DSC selection. You
can manually select the DBB setting that
best suits your listening environment.
MUTE (on remote control only)
This feature allows you to temporarily
switch off the sound without switching off
the system when you require a moment of
silence.
1 Press MUTE on the remote control to
switch off the sound.
™ "MUTE" will be displayed.
2 Press MUTE again on the remote
control or increase the VOLUME level
to switch on the sound.
pg 01-26/P75/22-Eng 3/6/00, 12:40 PM14