Philips FW-P88 - Page 11

3139 116 19711 (ENG)
11
7 Adjust the sound of all the speakers
until they are equal. When you are
satisfied with the setting, press TEST
TONE again to switch off the test
signal.
Note:
– It is advisable to set the speakers’ level
at normal listening level. "XX" denotes
the sound level.
When you have completed the Dolby
Pro Logic setup, you are ready to enjoy
Home Cinema sound.
• Press DPL (PRO
LOGIC) repeatedly
to select and cycle
through the various
sound modes.
Dolby Surround ™ Dolby
Center Phantom ™ Dolby 3
Stereo ™ Stereo ™ Dolby
Surround …
™ The Dolby Pro Logic display panel
will light up with the selection.
Dolby Surround
This setting is for a full Dolby Surround
Pro Logic mode.
• Press DPL to select the Dolby
Surround mode.
™ The message
“DOLBY
SURROUND”
will be
displayed.
™ The DPL
display panel will light up.
Dolby Center Phantom
This setting is for use without the
center speaker. It redistributes the
center speaker sound to the left and
right speakers, providing conventional
stereo across the front.
• Press DPL to select the Dolby Pro
Logic Center Phantom mode.
™ The message
“DOLBY
CENTER
PHANTOM”
will be
displayed.
™ The DPL display panel will light up.
Dolby 3 Stereo
Use this setting when full surround is
not required, but a wide stereo sound is
desired. It only requires the left, right
and center speakers.
• Press DPL to select the Dolby 3
Stereo mode.
™ The message
“DOLBY 3
STEREO” will
be displayed.
™ The DPL
display panel will light up.
Normal Stereo
This setting is for normal stereo sound
without Dolby Pro Logic. It only
requires the left and right speakers.
• Press DPL to select the Stereo
mode.
™ The message
“STEREO”
will be
displayed.
™ The DPL
display panel will light up.
DOLBY PRO LOGIC
PRO LOGIC
DPL TEST
T
LEFT CENTER RIGHT
SURR
SURR
LEFT CENTER RIGHT
SURR
SURR
LEFT CENTER RIGHT
SURR
SURR
LEFT CENTER RIGHT
SURR
SURR
Important!
1 For the best Dolby Pro Logic
sound, switch on DPL with DSC
set to “Classic” and with VEC off.
2 Dolby Pro Logic mode will
automatically switch to normal
Stereo mode when headphones
are connected.
3 Switch to normal stereo mode
when you record on a tape.
pg 01-28/P88/37-Eng 2/16/00, 9:13 AM11
All manuals and user guides at all-guides.com
all-guides.com