2-4
PCS 103 730
11
English
OPERATING THE SYSTEM
Easy Set
EASY SET allows you to store all available
radio stations automatically.
•Press and hold STANDBY ON
(on the
system only)
for
5 seconds
when the
system is in standby or demonstration
mode.
™ “EASY SET” will be displayed, and
followed by “TUNER” and then
“AUTO”.
™ EASY SET will start searching for all
radio on FM band and then followed
by radio stations on MW band.
™ All available radio stations with
sufficient signal strength will be
stored. Up to 40 presets may be
stored.
Notes:
– EASY SET will start with the FM band, if
there are still presets available, the
system will continue to store the MW
band.
– When EASY SET is used, all previously
stored radio stations will be replaced.
– The last preset radio station will appear
on the display when EASY SET is
completed.
Switching the system ON
•Press VCD, TUNER, TAPE or AUX.
You can also switch on the system by
pressing any one of the CD DIRECT PLAY
buttons.
You can also switch on the system by
pressing the OPEN•CLOSE or DISC
CHANGE button.
Switching the system to
standby mode
•Press STANDBY ON or B on the
remote control.
™ The system will switch to standby
mode.
Selecting the Source
• Press the respective source selection
button: VCD, TUNER, TAPE or AUX.
™ The display indicates the selected
source.
Note:
–For an external source, make sure you
have connected the audio left and right
OUT terminals of the external
equipment (TV, VCR, Laser Disc player,
DVD player or CD Recorder) to the AUX
IN terminals.
DIM mode
You can select the desired brightness for
the display.
•Press DIM to select DIM 1, DIM 2, DIM
3 or DIM OFF display mode.
™ The
DIM
appear on the display.
™ "DIM 1", "DIM 2", "DIM 3" or
"DIM OFF" will be displayed
depending on the mode selected.
DIM OFF - normal brightness with
Spectrum Analyzer On
DIM 1 - normal brightness with
Spectrum Analyzer Off
DIM 2 - half brightness with Spectrum
Analyzer On
DIM 3 - half brightness with Spectrum
Analyzer Off and all LEDs on the
system will be switched off.
Sound Control
VOLUME ADJUSTMENT
Adjust VOLUME to increase or decrease
the sound level.
For Personal Listening
Connect the headphones plug to the n
socket at the front of the system. The
speakers will be muted.
12
English
OPERATING THE SYSTEM CD-VCD
DIGITAL SOUND CONTROL (DSC)
The DSC feature enables you to enjoy
special sound effects that have preset
equalizer settings, providing the best music
reproduction.
•Press DSC to select OPTIMAL, JAZZ,
ROCK or TECHNO.
™ The Digital Sound Control display
panel will light up respectively.
™ “OPTIMAL, JAZZ, ROCK or
TECHNO” and the respective flag
will be displayed.
Note:
– When ”OPTIMAL” sound is selected,
DBB will be switched on automatically.
DYNAMIC BASS BOOST (DBB)
The DBB mode enhances the bass
response.
•Press DBB to switch on bass response.
™ The DBB button lights up.
™ “DBB ON” and the DBB flag will be
displayed.
To switch off DBB
•Press DBB again.
™ The DBB button light is switched off.
™ “DBB OFF” will be displayed.
Note:
– Some CDs or tapes might be recorded in
high modulation, which causes a
distortion at high volume. If this occurs,
switch off DBB or reduce the volume.
MUTE
(only on remote control)
This feature allows you to temporarily
switch off the sound of the system without
switching off the system when you require
a moment of silence.
•Press MUTE on the remote control to
switch off the sound.
™ "MUTE" and the MUTE flag will be
displayed.
•Press MUTE again on the remote
control or increase the VOLUME to
switch on the sound.
Warning!
1) This system is designed for conventional Discs. Do not use any accessories
such as disc stabilizer rings or disc treatment sheets, etc., which may damage
the disc mechanism.
2) Do not load more than one disc into each tray.
3) When the disc changer is loaded with Discs, do not turn over or shake the
system. This may jam the changer.
The CD part of this system also serves as a Video CD player if you connect it to
your TV set. You can load up to three discs in the disc changer for continuous
playback without interruption.
Before viewing the Video CD, ensure that the set is switched to corresponding
PAL or NTSC system of your TV set (exception Multi-system TV).
DIGITAL
SOUND
CONTROL
STANDBY
-
ON
PROGRAM DIM
MINI HIFI SYSTEM
CD1 • 2 • 3 BAND
TAPE 1 • 2
TAPEVCD TUNER
AUX
PRESET
▲
▲
TUNING
▲
▲
▲
▲
STOP• CLEAR
SEARCH
PLAY• PAUSE PREV NEXT
DISC CHANGE
DISC 3
OPEN
•
CLOSE
To Next Page
Loading...
