EasyManua.ls Logo

Philips FW-V28 - Page 3

Philips FW-V28
81 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
PCS 103 726
1-3
SPECIFICATIONS
GENERAL:
Mains voltage : 110-127V/220-240V Switchable
Mains frequency : 50/60Hz
Power consumption
Standby : < 15W (Demo mode off)
Active : 35W
Clock accuracy : < 4 seconds per day
Dimension centre unit : 265 x 310 x 320mm
TUNER:
FM
Tuning range : 87.5-108MHz
Grid : 50kHz
IF frequency : 10.7MHz ± 25kHz
Aerial input : 75ohm coaxial
Sensitivity at 26dB S/N : < 7µV
Selectivity at 600kHz bandwidth : > 30dB
Image rejection : > 25dB
Distortion at RF=1mV, dev. 75kHz : < 3%
-3dB Limiting point : < 8µV
Crosstalk at RF=1mV, dev. 40kHz : > 18dB
MW
Tuning range : 531-1602kHz / 530-1700kHz
Grid : 9kHz / 10kHz
IF frequency : 450kHz ± 1kHz
Aerial input : Frame aerial
Sensitivity at 26dB S/N : < 4.0mV/M
Selectivity at 18kHz bandwidth : > 18dB
IF rejection : > 45dB
Image rejection : > 28dB
Distortion at RF=50mV, m=80% : < 5%
AMPLIFIER:
Output power Left/Right : 2 x 15W RMS
1)
@ 6 ohm
Frequency response within ±3dB : 50Hz-15kHz
Dynamic Bass Boost : DBB On, DBB Off
2)
Digital Sound Control : Jazz, Techno, Optimal, Rock
2)
Input sensitivity
Aux-in : 700mV ± 3dB at 600ohm
Mic : 3.5mV ± 3dB at 600ohm
Output sensitivity
Headphone : 18mW at 32ohm
CASSETTE RECORDER:
Number of track : 2 x 2 stereo
Tape speed : 4.76 cm/sec ± 2%
Wow and flutter : < 0.4% DIN
Fast-wind/rewind time C60 : 130 sec
Bias system : 75kHz ± 10kHz
Rec/Pb frequency response within 8dB : 80Hz - 12.5kHz
Signal to noise ratio Type I : > 48dBA
Type II : > 52dBA
VIDEO CD:
Audio Performance
Measurement done at output conn. of the CDC module.
Frequency response within ± 3dB : 20Hz - 20kHz
Output level (in Vrms) : 500mV ± 2dB unloaded
Signal/Noise ratio (A-weighted) : > 80dBA
Distortion at 1kHz : < 0.003%
Channel unbalance at 1kHz : < 2dB
Channel separation at 1kHz : > 60dB
De-emphasis : 0 or 15/50 µS (Switched by subcode
on the disc)
Video Performance
Video output level : 1.0 ± 0.2Vp-p
Luminance non-linear distortion : < 0 ± 5%
Luminance S/N ratio : > 50dB
1)
±1dB, 1kHz, 10% THD
2)
Frequency response in each setting is software controlled.

Other manuals for Philips FW-V28

Related product manuals