3-1 3-1
DISMANTLING INSTRUCTIONS
Dismantling the DVD Module
Dismantling of the Cover Front Display
1) Loosen the 4 screws at top cover , 2 screws at slide Cover
and 4 screws at back panel as Figure 1 & 2.
2) Loosen the 4 screws at DVD loader bracket as Figure 3.
3) Loosen the 4 screws at DVD loader as Figure 4.
1) Remove the Volume knobs & Mic knob as stated in Dismantling the Cover Front Display in Figure 7 & 8.
4) Push the gear slowly towards the front as shown in figure
5 until the CDC tray starts to move out of the Front Cabinet.
The CDC tray is now disengaged and can be pulled out
completely.
Figure 4
Figure 3
Figure 2
A
Figure 1
5) Remove the Cover Tray as shown in figure 6.
Figure 5
Figure 6
Figure 7
Put out
Put out
Figure 8
Dismantling the Main board
1) Release 7 screws 'E' to free the Main board from the back panel Assembly as shown in Figure 9.
2) Loosen 1 screw 'G' at the side of the set as shown in Figure 10.
3) Release 2 screws ' F ' on bottom of the cover as shown in Figure 11.
Figure 9
F
Figure 11
G
Figure 10
To Next Page
Loading...
