24
English
Basic Functions
Plug and Play (for tuner installation)
Plug and play allows you to store all available
radio stations automatically.
If plug and play has not been installed
1 When you turn on the system, “AUTO
INSTALL- PRESS PLAY” will be displayed.
2 Press 38 to start installation.
➜ “INSTALL” will be displayed and followed by
“TUNER” and then “AUTO SEARCHING”.
➜ PROG will start to flash.
➜ The system will search all radio stations on
the FM band, and then the MW band.
➜ All available radio stations with strong signal
strength will be stored automatically.
➜ The system will stop searching when all
available radio stations are stored or when the
memory for 40 preset radio stations is full.
➜ The first preset radio station will play when
Plug and Play is completed.
Reinstalling plug and play
1 In Standby, press and hold SEARCH 33 on
the system until “AUTO INSTALL-PRESS
PLAY” is displayed.
2 Press 2; to start installation.
➜ All previously stored radio stations will be
replaced.
To exit without storing the plug and play
● Press STOP 7 on the system.
Note:
– If Plug and Play installation is not completed and
no station is preset, it will be reinitiated the next
time you power on the system.
To Next Page
Loading...
