Philips FWM352/BK - Controls; Controls on the System and Remote Control

10
English
Controls (illustrations on page 3)
Controls on the system and
remote control
1 STANDBY-ON B
– switches the system on or to standby mode.
2 Source selection – to select the following:
DISC (CD 1/2/3)
– to select disc tray 1, 2 or 3.
TUNER
– to select waveband: FM or MW.
TAPE
– to select tape deck.
AUX
– to select the input for an additional appliance:
AUX.
3 iR SENSOR
– infrared sensor for remote control.
4 MASTER VOLUME (VOL +/-)
– to increase or decrease the volume.
5 DBB
– to select the desired bass boost level. (DBB 1,
DBB 2, DBB 3 or DBB OFF).
6 DSC
– Selects different types of preset sound equaliser
settings (OPTIMAL, TECHNO, ROCK or JAZZ).
7 DISC 1/2/3
– to select a disc tray for playback.
8 Display screen
– to view the current status of the system.
9 OPEN•CLOSE
– to open or close the disc tray.
0 PROGRAM
for CD/ MP3-CD .. to programme disc tracks.
for Tuner ..................... to programme preset radio
stations.
! Mode Selection
ALBUM (-/ +) à á
SEARCH•TUNING
for MP3-CD ............. to select previous/next
album.
for CD/ MP3-CD .. (press and hold) to search
backward/forward.
for Tuner ..................... to tune to a lower or higher
radio frequency.
for Clock .................... to set the hour.
STOP Ç
for CD/ MP3-CD .. to stop playback or to clear a
programme.
for Tuner ..................... (on the system only) to stop
programming.
for Demo ................... (on the system only) to
activate/deactivate the
demonstration.
for Clock .................... to exit clock setting.
for Plug&Play ............ (on the system only) to exit
plug&play mode.
PLAY•PAUSE ÉÅ
for CD/ MP3-CD .. to start or interrupt playback.
PRESETí/ë ( TITLE)
for MP3-CD ............ to select previous/next title.
for CD ........................ to skip to the beginning of
the current, previous, or next
track.
for Tuner .................... to select a preset radio
station.
for Clock ................... to set the minute.
@ DISC CHANGE
–to change disc(s).
# CLOCK•TIMER
– to view the clock.
– set the clock or set the timer (on the set only).
$ n
– to connect headphones.
pg001-027_M352/371_55_Eng 2006.1.4, 16:1910