25
English
Setting the timer
The system can switch on to CD, TUNER or
USB PC LINK mode automatically at a preset
time, serving as an alarm to wake you up.
IMPORTANT!
– Before setting the timer, ensure that
the clock is set correctly.
– The volume of the timer will increase
gradually to the last tuned volume level.
If the last tuned volume level is too low,
the set will then increase to a
predetermined minimum audible level.
(00:00 / 12:00AM)
(00:
00 / 12:00AM)
(CD / TUNER / USB PC LINK)
52,
2
4
4
3
1,
1 Press and hold CLK/TIMER (or
CLOCK•TIMER on main unit) until “SELECT
CLOCK OR TIMER” is displayed.
2 Press ë to change the display to “TIMER” and
press CLK/TIMER again to confirm.
3 Press CD or TUNER or USB PC LINK to
select the wake-up source.
CD ™ “CD XX:XX”
TUNER ™ “ TU XX:XX”
USB PC LINK ™ “ USB XX:XX”
4 Press à or á (for hours) and í or ë (for
minutes) repeatedly to set the wake-up time.
5 Press CLK/TIMER to store the setting.
➜ The timer will always be switched on once it
has been set.
➜ icon remains on the display. It indicates the
timer is activated.
● At the preset time, the selected sound
source will be played for 30 minutes
before it switches to Eco Power standby
mode (if no button is pressed within the time
frame).
➜ CD – playing the first track of the last
selected disc. If the last selected disc tray is
empty, it will switch to the next available disc. If
all the disc trays are not available, it will switch to
Tuner mode.
➜ TUNER – playing the last tuned radio station.
➜ USB PC LINK – playing the last selected
playlist. If the connection fails, it will switch to
Tuner mode. Refer to “USB PC Link” for proper
connection and setup before use.
Activating/deactivating the timer
● Press TIMER ON/OFF on the remote control
to turn off the timer or turn on to the last
setting again.
➜ If activated, the timer information will display
for a few seconds, then the system resumes to
the last active source or stays in standby mode.
➜ If deactivated, “OFF” is displayed.
Notes:
– The system will exit timer setting mode if no
button is pressed within 90 seconds.
– The USB timer does not function when the
computer is in the standby mode.
Timer Operations
To Next Page
Loading...
