10
Problem Possible cause Solution
The appliance has
activated automatically. The
appliance enters the standy
10 minutes.
The appliance produces a
loud pumping sound.
The water tank is empty. Fill the water tank with water and press
the steam trigger until the pumping sound
the soleplate.
Water droplets come out
of the soleplate.
After the Calc-Clean process
remaining water may drip out
of the soleplate.
Wipe the soleplate dry with a piece of
Clean process (see chapter ‘Cleaning and
maintenance’).
The Calc-Clean process has not
You have to perform the Calc-Clean
process again (see chapter ‘Cleaning and
maintenance’).
Steam condenses into water in
the hose when you use steam
used it for a long time.
This is normal. Hold the iron away from the
garment and press the steam trigger.Wait
until steam instead of water comes out of
the soleplate.
Dirty water and impurities
come out of the soleplate.
Impurities or chemicals present
in the water have deposited
in the steam vents and/or
soleplate.
Perform the Calc-Clean process regularly
(see chapter ‘Cleaning and maintenance’).
Steam condenses into water in
the hose when you use steam
used it for a long time.
This is normal. Hold the iron away from the
garment and press the steam trigger.Wait
until steam instead of water comes out of
the soleplate.
soleplate.
You have accidentally started
the Calc-Clean process
(see chapter 'Cleaning and
maintenance').
the ‘iron ready’ light lights up steadily.
The Calc-Clean process
does not start.
You have not pressed the CALC-
until the appliance started
See chapter ‘Cleaning and maintenance’.
are water droplets on the
Steam has condensed on the
ironing session.
foam or felt material has worn out. You
can also add an extra layer of felt material
that is not designed to cope
with the high steam rate of the
appliance.
Put an extra layer of felt material under
English
9 / 160
To Next Page
Loading...
Need help?
General