Philips GC9040/02 - Auto Calc Clean Function

6 To iron with steam, set the temperature dial to 2 or higher.
7 Put the plug in an earthed wall socket.
Set the on/off knob to ‘on’.
The steam light ashes to indicate that the steam generator is heating
up. After 2 minutes the appliance is ready for use. You hear two beeps,
the steam light stops ashing and stays on. Press the steam trigger for
steam.
Type GC9040 only: To remove stubborn creases, you can use the steam
boost function. Set the temperature dial between
3 and MAX.
Press the steam boost button.
Never direct the steam at people.
8 Press the steam button to select the desired steam setting.
; for moderate steam output and # for high steam output (set a
temperature from 3 to MAX)
l for low steam output (set a temperature from 2 to MAX).
Note: If you do not use the iron for more than 10 minutes, the appliance
switches off automatically for safety reasons. The automatic shut-off light
ashes. To switch on the appliance again, press any button.

This appliance is equipped with an Auto Calc Clean function. Over
time, scale particles build up inside the steam generator. The appliance
automatically performs a Calc Clean process to clean itself from scale after
using 6 to 8 tanks of water.
-
-
-
-
-
OFF
O
N
OFF
O
N
O
N
O
N
O
FF
O
N
O
FF
O
N
ENGLISH 9