Philips GoPure GP5212 - How to restart GoPure car air purifier after a filter replacement

8
9
EN
High air purication power
Product air cleaning performance
Target pollutant
*
Clean air delivery
rate (CADR)
Cleaning energy
eciency grade
Particles
20m
3
/h
High eciency
Formaldehyde 6.5m
3
/h High eciency
Toluene
9.5m
3
/h
High eciency
TVOC
13m
3
/h
High eciency
NO2
16m
3
/h
High eciency
SO2
14m
3
/h
High eciency
Noise
*
(Sound power level) 55dB(A)
Birch pollen removal
**
90%
*
Complying with GB/T18801-2015, tested in 3m
3
chambe r
**
Airmid certied SelectFilter removes upto 90% airborne birch pollens
3 Remove the old lter
as shown.
4 Using the groove,insert a new
original GoPure lter.
m Important
The lter slides in only one way,
do not force it in.
See above.
5.2 How to restart GoPure car air purier after
a lter replacement
m Important
You must reset
the Philips GoPure device after
every lter replacement.
To reset your device after
replacing the lter:
1 Plug the device into the power
supply and ensure that it is
turned o.
2 Touch and hold the power
button over 3s until it emits a sound,
the lter replacement indicator is
blinking in red for 15s, lter reset
done once indicator turns o.
3 Car air purier purier operates
in the normal mode once top cover
is locked.
4 Repeat the above steps if the
lter reset fails.
m Important
For you safety,
GoPure car air purier will shut down
automatically whenever you open the
top cover.
2 Push the front side of cover.
take o top cover .