Philips GP7101 - Filter Reset Procedure; Resetting the Device After Filter Change

9
EN
3 Remove the old
lter as shown.
4 Using the
groove,insert a new
original GoPure lter.
m Important
The lter slides in only
one way, do not force
it in. See above.
5.2 How to restart GoPure car air purier
after a lter replacement
m Important
You must reset
the Philips GoPure
device after every
lter replacement.
To reset your device
after replacing
the lter:
1 Plug the device
into the power supply
and ensure that it is
turned off.
2 Touch and hold the
power button over 3s
until “ding ding” sound,
the lter replacement
indicator is blinking in
red for 15s, lter reset
done once indicator
turns off.
3 Car air purier
purier operates in the
normal mode once top
cover is locked.
n Important
For you safety,GoPure
car air purier will shut
down automatically
whenever you open the
top cover.
4 Repeat the above
steps if the lter
reset fails.