Philips Grind & Brew HD7762 - Self-Check Mode

HD7762
3-15
TECHNICAL INFORMATION
Self-Check mode
The appliance is equipped with a self-check mode, this enables you to quickly check the function of the main components of
the unit.
Keep the On/Off button pressed while
plugging the mains cord into the socket.
Left side
display
Right side display
Hardware version CH 201
Press any other button
Software version CH 0004
Press any other button
Heating element enabled CH 1
Press any other button
Heating element disabled CH 2
Press any other button
Grinder motor enabled CH 3
Press any other button
Grinder motor disabled + 6 Beeps CH 4
Press any other button
Microcontroller check CH 5 = ok E1 = Nok
Press any other button
Zero-cross detection CH 6 = ok E2 = Nok
Press any other button
Valve micro switches CH CLO = valve is closed
Press any other button CH ---- = valve is working
CH OPE = valve is open
Inspection window micro switch L- = Closed 8
Press any other button H- = Open 8
Thermostat CH 1111 = Thermostat closed
Press any other button CH 0000 = Thermostat open
Rotary knob 2 9
Press any other button
Rotary knob rotate clockwise Increasing 9
Rotary knob rotate anti-clockwise Decreasing 9
LED check All digits on All digits on
Press any other button
LED check All digits off All digits off
Press On/Off button
Stand-by