HD7762
8-15
REASSEMBLY INSTRUCTIONS
All the liquid seals, when broken, need to be replaced. This
includes cleaning the mating surfaces and applying suf cient
new liquid sealing.
Gasket of the Shower head
When the UI panel or Synchro motor has been removed,
special attention is needed to the proper wire routing from
top to bottom. All wires must pass through the slots as
indicated in red in the cross section below. They may not
be passed through the opening for the Grinder.
Bottom Cover
Upon reinstallation of the bottom cover, please mind that
the notch on the PCBA holder ts into the recess of the
bottom cover.
To Next Page
Loading...
