Philips HD3600/20 - Step 2: Placing the Tap Unit onto the Keg; Step 3: Placing the Tube into the Tap Unit

C
6 Place the preferred medallion on top of the handle.
Step 2: placing the tap unit onto the keg
C
1 Remove the protection cap and the tube from the keg.
Always clean the tap unit with hot water and, if necesary, with some
washing-up liquid before placing it on the keg and inserting the tube.
C
2 Put the tap unit onto the connection top of the keg by pushing
it down firmly.You will hear a click.
If you snap the tap unit onto the keg correctly, it will fit nicely between
the two chimes of the keg.
Step 3: placing the tube into the tap unit
Always clean the tap unit with hot water and, if necesary, with some
washing-up liquid before inserting the tube.
C
1 Insert the flexible tube into the tap body.
C
2 Slide the projections of the tube connector under the hinge
points.
ENGLISH 9