8 Closethelterholdersupport(Fig.6).
9 Place the jug on the hotplate (Fig. 7).
Make sure the lid is on the jug.
If the lid is not on the jug, the drip stop blocks the outow opening of the lter and the coffee does
not drip into the jug.
10Presstheon/offbuttontoswitchontheappliance(Fig.8).
11 Whenallthewaterhaspassedthroughthelter,youcantakethejugoutofthe
appliance (Fig. 9).
12 Afteryouhavepouredcoffee,putthejugwiththeremainingcoffeebackonthehotplateto
keepithot(Fig.10).
- For your convenience and safety, this appliance is equipped with an auto shut-off function. It
shuts itself off automatically after one hour. This also prevents the coffee from becoming too
bitter.
- However, coffee is at its best directly after it has been brewed (Fig. 11).
Drip stop
The drip stop prevents coffee from dripping through the lter onto the hotplate when you:
- remove the jug from the appliance for a moment (max. 30 seconds) towards the end of the
brewing process.
- remove the jug after the brewing process has nished.
After drinking coffee
1 Openthelterholdersupport(Fig.12).
2 Liftthelterholderwiththelteroutofthelterholdersupport(Fig.13).
3 Throwawaytheusedpaperlterwiththecoffeegrounds(Fig.14).
If you have used a permanent lter, empty it and rinse it under the tap.
Making another jug of fresh coffee right away
If you want to make another jug of fresh coffee right away, switch off the appliance and let it cool
down for three minutes. Fill the water tank again with cold water and put a new amount of ground
coffee in the lter. Now you can make fresh coffee again.
Note: If you do not let the appliance cool down for three minutes before you brew coffee again,
water starts dripping into the lter holder right away.
- Make sure you pour the rst amount of fresh water against the temperature sensor in the
centre of the water tank disc (Fig. 15).
When you do this, the outow opening in the bottom of the water tank closes again.
ENGLISH8