Philips HD5720/30 - Cleaning and Settings; Cleaning the Appliance

Cleaning
Regular cleaning prolongs the life of the appliance and guarantees optimal
brewing results for a long time.
1 Press the MENU button.
, The button lights up.
2 Press the ^ button until the message
‘START CLEANING?’ appears on the display.
3 Press the OK button.
, The message ‘ADD DETERGENT - Push OK when ready-’ appears
on the display.
4 Youcanputaspecialcleaningtabletintothegroundcoffeefunnel.
5 Fill the water tank to the MAX level.
6 Put a bowl with a minimum capacity of 1.5 litres under the coffee
spout.
7 Press the OK button.
The cleaning cycle takes up to 15 minutes if the water tank is lled to the
MAX level.
, The message ‘APPLIANCE IS CLEANING’ appears on the display
and the cleaning cycle starts
, Whenthecleaningcycleisnished,themessage‘CLEANING
DONE’ appears on the display.
Setting water hardness
1 Remove the Total Hardness Test strip (attached to page 2) from its
wrap. Dip the strip fully into the tap water you use to brew coffee
for a few seconds. Remove it and wait approx. 30 seconds (until one
or more squares turn red).
2 Press the MENU button.
, The button lights up.
3 Press the ^ button until the message ‘SET WATER HARDNESS?’
appears on the display.
4 Press the OK button.
5 Press the ^ button until the number on the display coincides with
the number of red squares on the test strip.
For example, if 3 squares on the test strip have turned red, you have to set
water hardness 3.
6 PresstheOKbuttontoconrmthesetwaterhardness.
ENGLISH20