Philips HDRW 720/17 - The Time Shift Buffer

23
Setting the time and date
If the time is still incorrect, this may be due to a weak or faulty TV
signal. In this case, switch off the automatic setting.
1 Press the BROWSER HDD button and then the SYSTEM
MENU button on the remote control.
P The 'SYSTEM MENU' appears.
2 Select 'Set up' using B .
3 Press C to select 'System'.
4 Select the line 'Installation' using B and confirm with C .
P A message appears on the screen that the change of this
setting will flush the 'Time Shift Buffer'.
O If the 'Time Shift Buffer ' contains important recordings, save
them with the REC/OTR n button first. Read additional
information to the 'Time Shift Buffer' in the chapter 'The Time
Shift Buffer'.
5 Select 'Yes' with D and confirm with OK .
O If the message window was closed, confirm the line with
C again.
6 Select 'Time/Date' using B or A and confirm with C .
a 'Not allowed' will appear on the TV screen
b The time/date will automatically be taken from the TV Guide On
Screen
™
System. Therefore you can not set the time/date manually.
7 Select 'Manual' with B or A .
8 Confirm with OK .
Time/Date
Manual
Time 09:02
AM/PM AM
Year 2004
Month 01
Date 01
Daylight Saving Off
To exit press
SYSTEM MENU
9 Change the time in 'Time' using the number buttons 0..9 on your
remote control.
0 Check 'AM/PM', 'Year', 'Month' and 'Date' in the same way.
Select the entry field with the B or A button.
If required, make changes using D , C or the number buttons
0..9 .
A In the line 'Daylight Saving', select one of the following:
'On': The time set corresponds to summer time (summer time
activated)
'Off': The time set corresponds to winter time (summer time
deactivated)
B When all the settings are correct, confirm with OK .
C To end, press SYSTEM MENU .
If the setting has been confirmed with OK the automatic system is
disabled
Additional installation features