Philips HeartStart Trainer User Manual

Prepares emergency responders to use HeartStart HSI Defibrillators in simulated scenarios.

Highlights simulated shock delivery, manikin compatibility, and pre-configured scenarios.

Details components on the front of the HeartStart Trainer, including PULL, ON/OFF, INFO buttons, and lights.

Details components on the back of the HeartStart Trainer, including battery compartment and IR port.

Describes the ON/OFF, i-button, shock button, speaker, and caution light functions.

Explains the training pads cartridge, its latch, and the battery compartment door.

Lists the items included in the HeartStart Trainer M5085A kit and optional accessories.

Provides step-by-step instructions for installing or replacing the four AA batteries.

Instructions for removing an existing training pads cartridge using the latch mechanism.

Step-by-step guide for inserting the M5073A or M5074A training pads cartridge.

Steps to apply the M5089A External Manikin Adapter to a training manikin.

Instructions for installing the M5088A Internal Manikin Adapter on Laerdal manikins.

Details on attaching the internal adapter to manikin skin for proper pad placement.

Procedure for choosing and initiating a specific training scenario using the i-button.

Steps to turn on the Trainer and prepare for a scenario, following voice prompts.

Guide for correct pad placement and continuing the scenario based on Trainer instructions.

How to complete, stop, repeat, or change scenarios, plus battery replacement notes.

Introduces the table detailing eight training scenarios and their descriptions.

Details Scenario 1: one shock for conversion, shockable and non-shockable rhythms.

Details Scenario 2: two shocks for conversion, shockable and non-shockable rhythms.

Covers Scenarios 3 (pad troubleshooting) and 4 (rhythm conversion cycles).

Covers Scenarios 5 (non-shockable rhythm) and 6 (multiple shocks).

Details Scenario 7: multiple shocks and rhythm conversion cycles.

Details Scenario 8: pad issues, multiple shocks, and non-shockable rhythms.

Explains how the Trainer mimics the Defibrillator and supports instructor-led training.

Highlights features not reproduced, incompatible cartridges, and setup configurations.

Steps to reapply pads to the yellow liner and wind the wires.

Instructions for closing the protective lid and snapping the cartridge handle into place.

Advice on avoiding heat, sunlight, and contamination for optimal pad performance.

Guidance on cleaning metal contacts on the training pads cartridge.

Addresses issues where the Trainer analyzes prematurely due to user touch or liner problems.

Troubleshoots scenarios where pads are old, disconnected, or the manikin adapter is faulty.

Troubleshoots Trainer not sensing yellow liner or difficult cartridge installation.

Guidance on proper disposal of electronic waste and battery disposal.