1 Remove the mains plug from the socket
and pull the appliance plug out of the
shaver.
C
2 Let the shaver run until it stops,undo the
screws and open the shaver.
3 Remove the batteries.
Do not connect the shaver to the mains again
after the batteries have been removed.
Troubleshooting
1 Reduced shaving performance.
B
Cause 1:the shaving heads are dirty.
B
The shaver has not been rinsed long enough or
the water used was not hot enough.
◗ Clean the shaver thoroughly before you
continue shaving (see 'Cleaning').
B
Cause 2:long hairs are obstructing the shaving
heads.
C
◗ Remove the retaining frame.
◗ Remove the hairs with the brush supplied.
C
◗ Clean the cutters and guards.
Do not clean more than one cutter and guard at
a time,since they are all matching sets.If you
accidentally mix up the cutters and guards,it may
take several weeks before optimal shaving
performance is restored.
ENGLISH 11
To Next Page
Loading...
