Philips HR2028 - Page 7

Caution
- Always unplug the blender before you assemble, disassemble or make adjustments to the
blender jar, the dry mill or the wet mill and before you start to clean the blender.
-
Never use any accessories or parts from other manufacturers or that Philips does not specically
recommend. If you use such accessories or parts, your guarantee becomes invalid.
- Do not exceed the maximum level indicated on the blender jar and the mill beakers.
- Noise level: Lc= 86 dB(A).
Blender
Warning
- Never reach into the blender jar with your ngers or an object while the appliance is running.
- Make sure the blade unit is securely fastened to the blender jar before you assemble the
blender jar onto the motor unit.
Caution
- Never ll the blender jar with ingredients hotter than 80ºC.
- To prevent spillage, do not put more than 1.5 litres of liquid in the blender jar, especially when
you process at a high speed. Do not put more than 1 litre in the blender jar when you process
hot liquids or ingredients that tend to foam.
- If food sticks to the wall of the blender jar, switch off the appliance and unplug it. Then use a
spatula to remove the food from the wall.
- Always make sure the lid is properly assembled on the jar and the measuring cup is inserted
properly in the lid before you switch on the appliance.
- Never forget to place the sealing ring on the blade unit before you connect the blade unit to
the blender jar, otherwise leakage will occur.
- Do not let the appliance run for more than 3 minutes at a time.
- Always let the appliance cool down to room temperature between processing cycles.
Dry mill and wet mill
Warning
- Do not use the dry mill to grind very hard ingredients such as nutmeg, Chinese rock sugar and
ice cubes.
- Do not use the wet mill to mix liquids or to crush ice cubes. Use the blender jar to process
these ingredients.
- Do not touch the cutting edges of the mill blade unit when you clean it. They are very sharp and
you could easily cut your ngers on them.
Caution
- Never use the dry mill or wet mill for more than 30 seconds without interruption.
Let the dry mill or wet mill cool down to room temperature between processing cycles.
- Let hot ingredients cool down before you process them in the dry or wet mill
(max. temperature 80°C).
- Never forget to place the sealing ring in the blade unit before you assemble the mill jar,
otherwise leakage occurs.
- Always process cloves, star anise and aniseed together with other ingredients. If processed
separately, these ingredients may attack the plastic materials of the appliance.
- The mill beakers may become discoloured when you use them to process ingredients such as
cloves, anise and cinnamon.
- The dry mill and wet mill are not suitable for chopping raw meat. Use the blender instead.
- Do not use the dry mill or wet mill to process liquids such as fruit juice.
- Do not process dry ingredients such as coffee beans and dried beans in the wet mill.
ENGLISH 7