Philips HR2028 - Page 8

Filter
Caution
- Never use the lter to process ingredients hotter than 80°C.
- Never overload the lter. Do not put more than 75g dried soy beans or 160g fruit in the lter
at the same time.
- Always make sure the lid is assembled properly and the measuring cup is inserted properly in
the lid before you switch on the appliance.
- Cut fruit into smaller pieces before you put it in the lter.
- Soak dried ingredients, such as soy beans, before you put them in the lter.
Built-in safety lock
This feature ensures that you can only switch on the appliance if you have properly assembled the
blender jar, the dry mill beaker or the wet mill beaker on the motor unit. If the blender jar or mill
beaker is correctly assembled, the built-in safety lock will be unlocked.
Electromagnetic elds (EMF)
This Philips appliance complies with all standards regarding electromagnetic elds (EMF). If handled
properly and according to the instructions in this user manual, the appliance is safe to use based on
scientic evidence available today.
Before rst use
Thoroughly clean the parts that come into contact with food before you use the appliance for the
rst time (see chapter ‘Cleaning’).
Using the appliance
You can adjust the length of the cord by winding part of it round the reel in the base. Pass the cord
through the slot in the base.
Blender
The blender is intended for ne pureeing, chopping and blending. With the blender you can prepare
soups, sauces and milk shakes. You can also use it to process vegetables, fruit, meat, pancake batter etc.
Preparing the blender for use
1 Assemble the sealing ring on the blender blade unit (Fig. 2).
2 Put the blade unit in the bottom of the blender jar (1). Screw the blade unit anticlockwise (2)
until it is xed properly. (Fig. 3)
3 Put the blender jar with the blade unit attached on the motor unit and x it by turning it
clockwise (‘click’). (Fig. 4)
The blender jar can be mounted in two positions: with the handle on the right side or on the left side.
4 Put the mains plug in the wall socket.
Using the blender
1 Put the ingredients in the blender jar.
2 Put the lid on the jar and turn it until it is rmly xed (‘click’).
3 Insert the measuring cup into the opening in the lid. (Fig. 5)
4 Press speed button 1 or 2 to switch on the blender.
After processing, press the pulse/off button to switch off the blender. If you want to process
ingredients very briey, use the pulse/off button instead of the speed buttons.
ENGLISH8