Philips HTL5140B - Resetting to Factory Settings; Software Update Guide; Checking Current Software Version; Updating SoundBar Software via USB

12 EN
Apply factory settings
You can reset this product to the default
settings programmed at the factory.
1 In any source mode, on the remote control
press Volume -, BASS -, and TREBLE - in
sequence within three seconds.
» When the factory settings restore is
complete, the product automatically
switches off and restarts.
5 Update software
To get the best features and support, update
your product with the latest software.
Check software version
In HDMI ARC source, on the remote control
press TREBLE -, BASS -, and Volume - in
sequence.
Update software via USB
1
Check the latest software version on
www.philips.com/support.
• Search for your model and click on
"Software and drivers".
2 Download the software into a USB storage
device.
a Unzip the download if zipped, and
makesurethattheunzippedleis
named "HTL5140.BIN".
b Putthe"HTL5140.BIN"leinthe
root directory.
3 Connect the USB storage device to the
(USB) connector on this product.
4 Switch this product to HDMI ARC source.
5 On the remote control, within six seconds
press
twice then Volume + once, and
then hold down SURROUND ON.
» "UPGRADE" (upgrade) blinks on the
display panel.
6 Press to start the upgrade.
» Then "UPGRADE" (upgrade) is
displayed on the display panel.
7 Wait until the upgrade is completed.
» If the upgrade is complete, this product
automatically turns off and on again.