To Next PageTo Next Page
Need help?Do you have a question about the Philips HTS3011 and is the answer not in the manual?
Picture/Display| D/A converter | 12 bit, 108 MHz |
|---|---|
| Picture enhancement | Progressive scan |
Sound| Total Power (RMS) | 200 W |
|---|---|
| Output power (RMS) | 4 x 25W + 2 x 50W |
| D/A converter | 24 bit, 192 kHz |
| Frequency response | 180 - 18000 Hz |
| Signal to noise ratio | >60 dB |
Power| Power supply | 110-240V, 50/60 Hz |
|---|---|
| Standby power consumption | < 1 W |
| Power consumption | 40 W |
Loudspeakers| Satellite speaker drivers | 3" full range woofer |
|---|---|
| Satellite speaker impedance | 4 ohm |
| Satellite speaker frequency range | 150-20000 Hz |
| Center speaker drivers | 3" full range woofer |
| Center speaker impedance | 8 ohm |
| Subwoofer driver | 6.5" high efficiency woofer |
| Subwoofer impedance | 8 ohm |
Dimensions| Set dimensions (W x H x D) | 360 x 55 x 332 mm |
|---|---|
| Set weight | 2.58 kg |
| Surround Speaker dimensions (W x H x D) | 100 x 95.5 x 83.5 mm |
| Surround speaker Weight | 0.47 kg |
| Subwoofer dimensions (W x H x D) | 131 x 315.5 x 386 mm |
| Subwoofer Weight | 3.6 kg |
Guidelines for handling delicate electronic components.
General warnings regarding electrostatic discharge (ESD).
Warnings about invisible laser radiation when unit is open.
Requirements for leakage current testing after servicing.
Rules for using lead-free solder, tools, and temperature settings.
Specific handling instructions for BGA ICs.
Instructions for changing the region code.
Steps for upgrading system software.
Flowchart for diagnosing and repairing the main unit.
Steps for diagnosing and resolving no sound issues.
Step-by-step guide to disassemble the front panel assembly.
Internal block diagram of the MT1389HD IC.
Internal block diagram of the STA308A IC.
Circuit diagram for the control section.
Internal IC diagram for the main board.
Circuit diagram for the main board.
Internal IC diagram for the power board.
Detailed IC diagram for AP3843GMTR.
Visual representation of unit's mechanical components.
