Philips HTS3154/12 - System & Software Configuration; System Settings; Software & Version Management

2 - 12 - 1
System , Region Code , etc. Setting Produre
1)System Reset
a) Press “system “ buttom on R/C,TV show “setup”.
b) Select the menu using the and
on R/C.
c) Go preference page to do sysytem reset.
3)Version Control Change
a) In open model, press “1“ “5“ “9“ on R/C.
b) Press “ok” buttom to com rm.
c) TV will show message as below:
2)Region Code Change
a) Press the “stop” buttom on R/C in open model.
c) Press”7” “3“ “4“ “4“ “6“ “6“ on R/C,then input desired number
to change region code :
1 USA
2 EU
3 AP
4 Australia ,NZ , Latam
5 Russia , INDIA
6 CHINA
Current model HTS3154-12
Ver 00.15.04-70123-01 region : 2
Servo: OF.60.00.00
8032: 05.00.04.06 RISC:00.00.02.02
IF current model does not match you set use down arrow
key on the remote to change
4)Password Change
a) Press “system “ buttom on R/C,TV show “setup”.
b) Select the menu using the and on R/C.
c) Go preference page select “password“ to change .
* 000000 is default password supplied.
5)Check on the Sofeware Version
a) Open the CD Door.
b) Press “display“ buttom on R/C .
c) TV will show the version on screen.
6)Trade model
a) Press “Open/Close” button in R/C.
b) Press “2” “5” “9” on R/C, VFD will display “TRA ON” or “TRA
OFF”.
6)Upgrading new sofeware
a) Open the CD Door,then insert the CD-R program disc
b) Close the DOOR
c) TV will show:
“loading“
pop message“upgrading“
“writhing” about 2 minutes
“done “
* The latest upgraded is in version VER 15.04-70123-01
CAUTION !
This information is co
n ncial and may not
be distributed. Only a qu
a d service
person s hould reprogram the Region Code.