14
: Restricts play to disc.
Password (PIN code) is required to
unlock the disc before play.
[Display Dim] : Changes the brightness
of the display panel.
[OSD Language] : Selects the on-
screen display menu language.
: Enables or disables
screen saver mode. If enabled, the
screen enters idle mode after 10
minutes of inactivity (for example, in
pause or stop mode).
[Sleep Timer] : Sets a sleep timer to
switch the home theater to standby
[Auto Standby] : Enables or disables
auto standby. If enabled, the home
theater switches to standby after 30
minutes of inactivity (for example, in
pause or stop mode).
: Displays the
DivX VOD registration code for the
home theater.
4 Press OK
Note
Before you purchase DivX videos and play
them on the home theater, register the home
theater on www.divx.com using the DivX
VOD code.
Change audio settings
1 Press SETUP.
2 Select [Audio Setup], then press OK.
3 Select and adjust the following settings:
: Sets the volume
of each speaker to obtain the ideal
audio balance.
: Sets the delay time
for center and rear speakers to obtain
an equal audio transmission from all
the speakers.
[HDMI Audio] : Enables or disables
HDMI audio output for the TV.
[Audio Sync] : Sets a delay for audio
output when you play a video disc.
6 Change settings
This section helps you to change the settings of
your home theater.
Caution
with the best value for the home theater.
setting, it is best to leave it at the default value.
Access the setup menu
1 Press SETUP.
» The following menu appears.
Symbol Description
[General Setup]
[Audio Setup]
[Video Setup]
[Preference Setup]
2 Select a setup menu, then press OK.
See the following sections for information
about how to change the settings of your
home theater.
3 Press BACK to return to the previous
menu, or press
SETUP to exit.
Note
You cannot change a setting that is grayed out.
Change general settings
1 Press SETUP.
2 Select [General Setup], then press OK.
3 Select and adjust the following settings:
EN
To Next Page
Loading...
