Philips InnoSpire Go - Electromagnetic compatibility (EMC); Electromagnetic emissions

160
Guidance and manufacturer’s declaration – electromagnetic emissions
The InnoSpire Go is intended for use in the electromagnetic environment specified below. The customer or
the user of the InnoSpire Go should assure that it is used in such an environment.
Emissions test
Group 1
RF emissions
CISPR 11
The InnoSpire Go uses RF energy
only for its internal function.
Therefore, its RF emissions are
very low and are not likely to
cause any interference in nearby
electronic equipment.
Compliance Electromagnetic environment –
guidance
Class B
RF emissions
CISPR 11
Class A
Harmonic emissions
IEC 61000-3-2
The InnoSpire Go is suitable for
use in all establishments, including
domestic establishments and those
directly connected to the public
low-voltage power supply network
that supplies buildings used for
domestic purposes.
Complies
Voltage fluctuations/
flicker emissions
IEC61000-3-3
A. Instructions for use
1. The InnoSpire Go needs special precautions regarding EMC and needs to be installed and put into service
according to the EMC information provided in this document;
2. Portable and mobile RF communications equipment can affect the InnoSpire Go.
B. Technical description
1. Warning: the use of accessories, transducers and cables other than those specified, with the exception of
transducers and cables sold by the manufacturer of the InnoSpire Go as replacement parts for internal
components, may result in increased EMISSIONS or decreased IMMUNITY of the InnoSpire Go;
2. Warning: the InnoSpire Go should not be used adjacent to or stacked with other equipment.
3.
1128271R02_InnoSpireGo_Euro2_Spreads_IFU_10B_FINAL.indd 160 11/8/17 5:07 PM