5
Measurement Server
Extensions
The optional measurement server extensions connect
to the MMS and use the MMS settings and power.
Trend data and measurement settings from the
measurements in the extensions are stored in the
measurement server.
The measurement server extensions are not intended to
be disconnected from the MMS. To exchange an
extension, you must exchange the measurement server
and extension together.
The measurement server extensions must not be
disconnected from the host measurement server during
monitoring. When the extension is disconnected, all
measurement server and extensions settings revert to
default and any trend data stored in the measurement
server is lost.
Note: MP20/MP30 require an additional option (C30)
to be used with the extensions’ optional Cardiac
Output and Continuous Cardiac Output. MP20Junior
cannot be used with these measurements.
M3014A, M3015A and M3016A CO
2
Extensions
The M3014A Capnography Extension adds
mainstream capnography, and optionally one pressure
plus either a pressure or a temperature, Cardiac Output
and Continuous Cardiac Output to the MMS. The
M3015A Microstream CO
2
Extension adds
microstream capnography and optionally either
pressure or temperature to the MMS. The M3016A
Mainstream CO
2
Extension adds mainstream
capnography and either pressure or temperature to the
MMS.
M3012A Hemodynamic
Measurement Server Extension
The optional M3012A Hemodynamic Measurement
Server Extension (HMSE) can be connected to the
M3001A Multi-Measurement Server to provide the
following additional measurements: Temperature,
Pressure, an additional Pressure or Temperature, and
optionally C.O. and CCO measurements.
To Next Page
Loading...
Need help?
General
