3 Configuring Screens Changing the Content of Screen Elements
24
Displaying Timers on the Main Screen
MX800
MP5-90
only
If you want to have a timer displayed on the Main Screen, you can substitute it for a numeric which is not
directly associated with a wave or a Screen Trend.
To display a timer on the Main Screen,
1 Select the numeric you want to substitute.
2 Select Change Numeric.
3 Select Any Timer. The monitor automatically uses the timer label with the highest priority that is
not displayed on the Screen yet. See "Configuring Timers" on page 158.
Be aware of the following restrictions:
• If limited space is available, some elements displayed in the Timers window may not be displayed. The
minimum information displayed is the elapsed or remaining time.
• The maximum number of timers that can be displayed on the Main Screen depends on your monitor
model:
– MX800, MP60-90: four timers
– MP40-50: three timers
– MP5/MP5T/MP5SC/MP20-30: two timers
–MP2/X2: no timer
• Any timer label can only be used once per Screen.
Displaying a Clock on the Main Screen
MX800
MP5-90
only
If you want to have a clock displayed on the Main Screen, you can substitute it for a numeric which is not
directly associated with a wave or a Screen Trend.
To display a clock on the Main Screen,
Pulse X X X MX800, MP20 -90 monitors only
Any Perf XXX
tcpCO
2
XX
CO
2
XXX
ABP XXX
PAP XX
CVP XXX
ICP XXX
CPP XXX
BIS XXX
CCO XXX
AWP XXX
Any Agent X
Delta SpO
2
X
inO
2
XX
H10 / H40 H20 H30 Comments
To Next Page
Loading...