Changing the Content of Screen Elements 3 Configuring Screens
23
• The changed Screen is not part of the monitor configuration and can therefore not be cloned to another
monitor using the IntelliVue Support Tool.
• The changed Screen can be modified with the Screen Editor of the IntelliVue Support Tool.
For more details regarding the configuration of the XDS Remote Display, refer to the Installation and
Configuration Guide for the XDS Application.
Changing the Content of Screen Elements
Changing the Content of a Wave Element
To change the content of a wave element on a Screen,
1 Select the wave you want to change.
2 From the wave menu that appears, select Change Wave and then select the wave you want to be
displayed.
Changing the Content of a Numeric Element
To change the content of a numeric element on a Screen,
1 Select the numeric you want to change. You can only change numerics that are not directly associated
with (aligned to) a wave or a Screen Trend.
2 From the Setup menu that appears, select Change Numeric and then select the numeric you want
to be displayed.
Changing the Content of a Screen Trend Element
To change the content of a screen trend element on a Screen,
1 Select the screen trend you want to change. You can only change a Screen Trend that is not directly
associated with (aligned to) a wave.
2 From the trend menu that appears, select Change Trend and then select the screen trend you want
to be displayed.
Changing the Content of a High Resolution Trend Element
MX800
MP5-90
only
To change the content of a HiRes Trend element on a Screen,
1 Select the HiRes Trend you want to change.
2 From the menu that appears, select the HiRes trend you want to be displayed.
Depending on the H option (see "Understanding H and M Options" on page 31) and C option of your
monitor, the following parameters are available for selection:
H10 / H40 H20 H30 Comments
btbHR X X X These 4 parameters are included in the OxyCRG option
(C08)
MP5: tcpO
2
not available.
Any SpO
2
XXX
Resp XXX
tcpO
2
X
To Next Page
Loading...