21
English
10 Press the flashing button to start the flushing cycle. The ristretto button is on
and the lungo button flashes during the flushing phase
Note: The water tank will be emptied without interruption. The flushing cycle
lasts about 3 minutes.
11 When the flushing cycle has finished, the ristretto and lungo button flash a
few times.
Note: It is normal that some water remains behind in the water tank after the
descaling procedure.
The machine switches off. The descaling procedure is finished.
Meaning of light signals
-
The selected coffee button flashes slowly: the machine is preparing your
drink.
-
The selected coffee button flashes quickly: the water tank is empty, fill the
water tank with tap water.
-
The selected coffee button flashes intermittently: The new coffee quantity is
saved and programming is active.
-
The ristretto and lungo button flash simultaneously after brewing coffee: you
need to descale the machine.
-
All three buttons flash simultaneously: the machine needs to cool down. Wait
approx. 2 minutes before you start brewing a new drink.
Troubleshooting
This chapter summarizes the most common problems you could encounter with
your machine. If you are unable to solve the problem with the information
below, visit www.lorbarista.com/support for a list of frequently asked questions
or contact the Consumer Care Center in your country.
Problem Possible cause Solution
The machine does not switch
on.
The machine is not connected to the
mains.
Put the plug in an earthed wall
socket.
The coffee does not flow out of
the machine immediately when
I press the button.
The machine needs a few seconds to
heat up before it starts brewing.
This is normal.
The brewing time is longer than
before.
The machine is clogging up with
scale.
Descale the machine.
To Next Page
Loading...
