3 After about 1 second, the READY/skin colour
warning light comes on. This shows that the appliance
is ready to release a ash.
4 Press the on/off/intensity button one or more
times to choose the intensity level suitable for the
treatment area and your skin colour.
5 Make sure that the treatment area is clean, dry
and properly shaved. Place the skin contact surface
on the skin. When the skin contact surface is in
full contact with the skin, the READY/skin colour
warning light starts blinking slowly.
6 Press the ash button. The skin colour sensor checks
the colour of your skin. If the skin colour allows safe
treatment, the READY/skin colour warning light goes
off. The appliance delivers a ash to the skin and
makes a soft popping sound.
Note: If the appliance releases no ash and the READY/skin
colour warning light blinks rapidly, your skin colour is too dark
for safe treatment. If you have recently tanned skin, wait for
2 weeks (see chapter ‘Contraindications, precautions and
warnings’, section ‘Warning about sun exposure and tanning’).
7 The appliance immediately recharges for the next ash.
Depending on the intensity level selected, the READY/
skin colour warning light comes on after a few seconds.
This indicates that the appliance is ready for the next
ash. Choose one of the ash delivery methods and
continue to treat the areas you want to treat.
ENGLISH 19
To Next Page
Loading...
