Philips Lumea Prestige BRI956 - Handling the Lumea Device (Continued); Treatment Modes: Stamp & Slide

5 Press the device rmly onto your skin to ensure proper skin contact. The
‘ready to ash light’ on the back of the device lights up white to indicate
that you can proceed with the treatment.
Note: When the ‘ready to ash’ light starts blinking orange, your skin is
not suitable for treatment. In this case, the device automatically disables.
You can try to use the device on other areas with a lighter skin tone.
Note: If the ' ready to ash' light does not light up white, the device is not
completely in contact with your skin.
TIP: If you use Lumea on your bikini area and want to leave some hair in
place, make sure that the skin tone sensor is not placed on the remaining
hair during the treatment, as this can cause the device to block.
6 Press the ash button to release a ash. The devices makes a soft
popping sound. You should feel a warm sensation because of the ash.
Note: The scattered light produced by the device is harmless to your
eyes. Do not look at the ash while using the device. It is not necessary
to wear goggles during use. Use the device in a well-lit room so that the
light is less glaring to your eyes.
7 Place the device on the next area to be treated. After each ash, it takes
up to 2 seconds until the device is ready to ash again. You can release a
ash when the 'ready to ash' light lights up white.
8 To make sure that you have treated all areas, release the ashes close to
each other. Eective light only comes out of the light exit window. Part
of the device that is in contact with your skin is slightly larger therefore
there should be some overlap. However, make sure you ash the same
area only once.
Note: Flashing the same area twice does not improve the eectiveness of
the treatment, but increases the risk of skin reactions.
Note: Do not use any pencil or pen to mark the areas to be treated, as
this may cause side eects to your skin.
9 When you have nished the treatment, press and hold the on/o button
to switch o the device. Remove the adapter from the wall socket if you
used the device corded.
Note: If you did not use the device for a long period of time, it is important to
perform a skin test again and have it charged to avoid deep discharge.
Two treatment modes: Stamp & Flash and Slide & Flash
- Your Philips Lumea has two treatment modes for more convenient use
on dierent body areas:
- The Stamp & Flash mode is ideal to treat small or curvy areas like knees
and underarms. Simply press and release the ash button to release a
single ash.
23
English