Philips MC 30 - Tuner and Radio Operations; Tuning and Storing Radio Stations

15
English
3140 115 2xxx1
Tuner
TUNING
CLOCK
SIDE A/B
VOLUME
SHUFFLE
SOURCE
TIMER ON•OFF PROGRAM
REPEAT
REV MODE/ BAND
STANDBY-ON
RECORD
MC
-
30 MICRO SYSTEM
iR
FWD á/ë
REW à /í
PRESET
STOP
PLAY•PAUSE
Tuning to radio stations
1 Select TUNER source.
➜ TUNER is displayed briefly.
2 Press BAND once or more to select your
waveband.
3 Press down on TUNING 4 or 3 and release
button.
➜ The radio automatically tunes to a station
with sufficient reception. Display indication during
automatic tuning: SEARCH.
➜ If a FM station is received in stereo, STEREO is
shown.
4 Repeat step 3 if necessary until you find the
desired station.
¶ To tune to a weak station, press TUNING 4 or
3briefly and repeatedly until you have found
optimal reception.
Programming radio stations
You can store up to a total of 40 radio stations
in the memory.
Automatic programming
Automatic programming will start with a chosen
preset number. From this preset number
upwards, former programmed radio stations will
be overridden. The system will only program
stations which are not in the memory already.
1 Press PRESET 4 or 3 ( ¡ or ™ on the
remote control) to select the preset number
where programming should start.
Note:
– If no preset number is selected, default is preset
(1) and all your presets will be overridden.
2 Press PROGRAM on the system or remote
control for more than 2 seconds to activate
programming.
➜ AUTO is displayed and available stations are
programmed in order of waveband reception
strength: FM followed by AM. The last preset
automatically stored will then be played.
Manual programming
1 Tune to your desired station (see Tuning to radio
stations).
2 Press PROGRAM on the system or remote
control to activate programming.
➜ PROGRAM flashes in the display.
3 Press PRESET 4 or 3 (¡ or ™ on the remote
control) to allocate a number from 1 to 40 to
this station.
4 Press PROGRAM again to confirm the setting.
➜ PROGRAM disappears, the preset number and
the frequency of the preset station are shown.
5 Repeat the above four steps to store other
stations.
¶ You can override a preset station by storing
another frequency in its place.
Tuning to preset stations
¶ Press PRESET 4 or 3 ( ¡ or ™ on the
remote control) until the desired preset station
is displayed.
pg 001-021/MC30/37-Eng 12/8/00, 9:09 AM15