Philips MC138 - CD Playback Operations; Playing a Disc; Track Navigation

14
English
MC138/17 English issue 1
CD Operation
IMPORTANT:
The lens of the CD player should never be
touched.
Playing a disc
This CD player plays Audio Discs including CD-
Recordables and CD-Rewritables.
¶ CD-ROM, CD-I, CDV, VCD, DVD or computer
CDs, however, are not possible.
1 Select CD source.
2 Press OPEN•CLOSE on the
top of the system to open the
CD compartment.
➜ OPEN is displayed when
you open the CD compartment.
3 Insert a disc with the printed side facing up and
press down on OPEN•CLOSE to close the
CD door.
➜ rEAd is displayed as the CD player scans
the contents of a disc. The total number of
tracks are also shown.
4 Press 2; to start playback.
➜ Current track number followed by elapsed
playing time of the track are displayed during disc
playback.
5 To pause playback press 2;.
➜ The display freezes and the current track
number flashes when playback is paused.
6 Press 2; again to resume play.
7 To stop disc playback, press 9.
Note: CD play will also stop when;
– the CD door is opened.
– the disc has reached the end.
– you select another source: TAPE, TUNER.
– you select standby.
– you press the tape deck PLAY 2 key.
Selecting a different track
● Press ¡1 or 2™ (í or ë on remote control)
once or repeatedly until the desired track
number appears in the display.
● If you have selected a track number shortly after
loading a disc, or in the PAUSE position, you will
need to press 2; to start playback.
Finding a passage within a track
1 Press and hold down ¡1 or 2™ (à or á on
remote control).
➜ The disc is played at high speed and low
volume.
2 When you find the passage you want, release
¡1 or 2™ (à or á on remote control).
➜ Normal playback continues.
Note:
– During a disc programme or if SHUFFLE/
REPEAT active, searching is only possible within the
same track.