16
English
MC138/17 English issue 1
Radio Reception
Tuning to radio stations
1 Select TUNER source.
➜ tU is displayed briefly.
2 Press SOURCE (TUNER on the remote
control) once or more to select your waveband.
3 Press on TUNE à or á and release button.
➜ The radio automatically tunes to a station
with sufficient reception. Display indication during
automatic tuning Srch.
4 Repeat step 3 if necessary until you find the
desired station.
● To tune to a weak station, press TUNE à or
á briefly and repeatedly until you have found
optimal reception.
Programming radio stations
You can store up to a total of 30 (20 FM and 10
AM) radio stations in the memory.
Automatic programming
Automatic programming will start with a chosen
preset number 1. From this preset number
upwards, former programmed radio stations will
be overridden.
1 Press SOURCE (TUNER on the remote
control) once or more to select your waveband.
2 Press ¡ or ™ (on the remote control) to select
the preset number where programming should
start.
Note:
– If no preset number is selected, default is preset
(1) and all your presets will be overridden.
3 Press PROGRAM (PROG on the remote
control) for more than 2 seconds to activate
programming.
➜ AUto is displayed and available stations are
programmed in order of waveband reception
strength.
Manual programming
1 Tune to your desired station (see Tuning to radio
stations).
2 Press PROGRAM (PROG on the remote
control) to activate programming.
➜ PROGRAM flashes in the display.
3 Press ¡ or ™ (on the remote control) to select
a number from 1 to 20 for FM (or 1 to 10 for
AM) to this station.
4 Press PROGRAM (PROG on the remote
control) again to confirm the setting.
➜ PROGRAM disappears and the frequency of
the preset station is shown.
5 Repeat the above four steps to store other
stations.
● You can override a preset station by storing
another frequency in its place.
Tuning to preset radio stations
● Press ¡ or ™ (on the remote control) until the
desired preset station is displayed.
To Next Page
Loading...
