English
13
CD/MP3-CD Operation
To find a passage within a track
1 Press and hold the control knob on the front
panel to the left or right (corresponding to
S/T) or press 5 /6 on the remote.
2 When you recognize the passage you want,
release the control knob (5 /6 on the
remote).
➜ Normal playback continues.
➜ To resume, press ENTER/ÉÅ again.
To stop playback
● Press CANCEL / 9 .
To interrupt playback
● Press ENTER/ÉÅ during playback.
➜ The display freezes and the elapsed playing
time flashes when playback is interrupted.
Notes:
CD play will also stop when;
– the CD door is opened.
– the disc has reached the end.
– you select another source: TUNER, DAB or AUX.
– you select standby.
– the set auto off time arrives.
To scan all discs in a disc
● Press INTRO/SCAN on the remote to play
the first 10 seconds of each track in the whole
disc one by one.
➜ INTRO appears on the display.
➜ The playback will start from the first track of
the current disc.
To scan all discs in a disc
● Press INTRO/SCAN on the remote again
until INTRO disappears.
Playing an MP3 disc
1 Load an MP3 disc.
➜ The disc reading time may exceed 10
seconds due to the large number of songs
compiled into one disc.
2 Press ALB +/- on the remote to select a desired
album.
3 Press the control knob on the front panel to the
left or right (corresponding to S/T) or
press ¡ / ™ on the remote to select a desired
track.
➜ The album number will change accordingly as
you reach the first track of an album by pressing
S (¡ on the remote) or the last track of an
album by pressing T (™ on the remote).
4 Press ENTER/ÉÅ to start playback.
Supported MP3 disc formats:
– ISO9660, Joliet
– Maximum title number: 512 (depending on
filename length)
– Maximum album number: 255
– Supported sampling frequencies: 32 kHz,
44.1kHz, 48 kHz
– Supported Bit-rates: 32~256 (kbps), variable
bitrates
pg001-021_MCB700_05 2006.10.25, 17:1113
To Next Page
Loading...
