Philips MCD708/05 - Getting Started; Step 3: Setting language preference; Setting the OSD Language; Setting the Audio, Subtitle and Disc Menu language

20
English
Step 3: Setting language
preference
You can select your preferred language settings.
This DVD system will automatically switch to the
selected language whenever you load a disc. If
the language selected is not available on the disc,
the default language for the disc will be used
instead. The OSD language in the system menu
will remain once selected.
Setting the OSD Language
1 Press SYSTEM.
2 Press 1 2 to select “GENERAL SETUP
PAGE”.
3 Use 1 2 3 4 on the remote control to
navigate in the menu.
Move to “OSD LANGUAGE” and press 2.
4 Select a language and press OK.
To exit from the menu
● Press SYSTEM again.
Getting Started
Setting the Audio, Subtitle and Disc
Menu language
1 Press SYSTEM in stop mode.
2 Press 1 2 to select “PREFERENCE PAGE”.
3 Press 3 4 to highlight the following in the
Preference Page.
–“AUDIO” (disc’s soundtrack)
–“SUBTITLE” (disc’s subtitles)
–“DISC MENU” (disc’s menu)
4 Enter its submenu by pressing 2.
5 Select a language and press OK.
6 Repeat steps 3~5 for other language settings.
To exit from the menu
● Press SYSTEM again.
If you choose OTHERS in Audio, Subtitle
or Disc Menu,
1 Press 3 4 to highlight “OTHERS”.
2 Press OK.
3 When you are asked to enter a language code,
enter a language code using the Numeric
Keypad (0-9).
4 Press OK to confirm.
pg 001-039_MCD708_-22 2006.10.31, 15:4620