Setting the clock
1
2
3
4
In standby mode, press and hold CLOCK on the remote.
When the hour digits flash, turn VOLUME-/+ on the system or press VOL +/- on the
remote to set the hours.
Press CLOCK again and the minute digits flash. Then turn VOLUME-/+ on the system or
press VOL +/- on the remote to set the minutes.
Press CLOCK again to confirm the time setting.
Setting DVD menu options
IMPORTANT!
If the progressive scan feature is activated but the connected TV does not support
progressive signals or the cables are not connected accordingly, see the user
manual for proper progressive scan setup or deactivate the progressive scan
feature as below:
1) Turn off your TV progressive scan mode or turn on to interlaced mode.
2) Press SYSTEM MENU on the remote to exit the system menu and then DISC
and “1” to exit progressive scan.
Tip
See chapters "Getting Started" and "System Menu Options" in the
User Manual for detailed descriptions.
DIVX (R) VOD
3D PROCESSING
DIGITAL AUDIO SETUP
PICTURE SETTING
MCD716 QUG_98_Eng 2008.1.30, 12:533
To Next Page
Loading...
