Philips MCD908/12 Quick Start Guide

Setting the clock
1
2
3
4
In standby mode, press and hold CLOCK on the remote.
When the hour digits flash, turn VOLUME-/+ on the system or press VOLUME+/- on the
remote to set the hours.
Press CLOCK again and the minute digits flash. Then turn VOLUME-/+ on the system or
press VOLUME+/- on the remote to set the minutes.
Press CLOCK again to confirm the time setting.
Setting DVD menu options
IMPORTANT!
If the progressive scan feature is activated but the connected TV does not support
progressive signals or the cables are not connected accordingly, see the user
manual for proper progressive scan setup or deactivate the progressive scan
feature as below:
1) Turn off your TV progressive scan mode or turn on to interlaced mode.
2) Press SYSTEM on the remote to exit the system menu and then DISC and “1”
to exit progressive scan.
Tip
See chapters "Getting Started" and "System Menu Options" in the
User Manual for detailed descriptions.
MCD908 QUG_12_Eng 2007.1.15, 17:003

Philips MCD908/12 Specifications

General

Brand	Philips
Model	MCD908/12
Category	Home Theater System
Language	English