Philips MCM3000 - Page 5

TECHNICAL DESCRIPTION
2X60W
GENERAL PART
Output Stage Protection: Temperature:
Y
es;
INDICATORS
V
FD DISPLAY W/BACK-LIGHT
ELECTRICAL DAT
A
DSC: N
A
Support Disc
DBB Yes
IS: N
A
MAX: N
A
VEC: N
A
Level Difference: '+/-3 dB
Tuner: FM 67.5 kHz Modulation.
CD: -6 dB track(Audio Disc 1 ,Trk 35)
Ipod&Iphone: 500mW
A
ux : 500mV; Rs=600Ω Headphone Out:
Input Sensitivity (±3dB)for Rated Output Power at 1KHz
Microphone Sens: N
A
A
coustic Hum Noise in dB (Volume = 1): 30dB
Channel Difference: 3 dB 33dB
Hum (VOL1 to default value): 200 nW
Residual Noise (Volume Minimum) :
60 nW
Channel Seperation: 40dB at 1KHz /35dB at 16KHz /30 dB at 20KHz
signal to noise ratio : 65 dB
A
Shock sens.: >3g
OUTPUT POWER(4 ohm Loading)
Mains Operation : 2 X 60W(NORMAL)
Frequency Response 100Hz ~ 16KHz within +3/-3dB (@ REF output )
ipod&iphone Compatibility: iPod 5G, iPod nano 1G/2G/3G,
Classic, iPod Touch, iPhone included 3GS Iphone4 Ipad
ipod&iphone charging : 2100m
A
2
X
55W(LIMIT)
2.5 mW - 2 dB , R Load = 32 ohm @ max
At cold condition with 10%THD 1KHz
(Euro & Nafta)
CD-DA CD-R/RW MP3
0dB, 1kHz CD
(Apac & Latam)
Power Standby Mode:
LOUDSPEAKER(BOXES)
Rated Impedance : Left/Right:
4Ω @ 100 Hz ~ 15kHz
Matrix: N
A
REMARKS
(*1) Deviations from PQR
(*2)
Revise
CD MICRO SYSTEM
Tot.Sh.:
Electronical Parameters are to be measured at speaker terminal across
input singal in cd mode setting in DBB Off unless specified otherwise.
ohm load with
SET SPECIFICATION
SHEET 4 Name: 7
Check: Date:
Date:2010-11-15