Philips MCM700/12 - SPECIFICATION; AMPLIFIER SPECIFICATION; CD PLAYER SPECIFICATION; TUNER SPECIFICATION

Tip
See the User Manual for how to
connect other equipment to this
system.
1
2
3
4
In standby mode, press and hold CLOCK on the remote.
When the hour digits flash, turn VOLUME-/+ on the system or press VOL+/- on the
remote to set the hours.
Press CLOCK again and the minute digits flash. Then turn VOLUME-/+ on the system or
press VOL+/- on the remote to set the minutes.
Press CLOCK again to confirm the time setting.
1
2
4
3
Connect the speaker cables.
Connect the FM antenna.
Connect the control cable.
Connect the power cord of the system.
Speaker
(right)
Speaker
(left)
FM antenna
AC power cord
Setting the clock
IMPORTANT!
– To set clock in the Eco Power mode, press and hold ECO POWER/STANDBY-ON
2 on the set for 3
seconds or more to switch to normal standby mode first before proceeding with the procedures below.
MCM700 QSG_Eng 2007.3.8, 13:312