Philips MZ-7 - Operating the System

14
English
Important:
Before you operate the system,
complete the preparation procedures.
Demonstration mode
The system has a demonstration mode that
shows the various features offered by the
system.
When the system is switched
on for the first time, the demonstration
mode will start automatically.
Notes:
– During the demonstration, if you press
any source (or standby-on) button, the
system will switch to the respective
mode (or standby).
– When the system is switched to standby
mode, the demonstration will resume
five seconds later.
To stop the demonstration mode
• Press and hold STOP
(on the system
only)
for five seconds when the system
is in demonstration mode.
™ The demonstration will stop.
™ "DEMO OFF" is displayed.
™ The system will switch to standby
mode.
Note:
– Even though the AC power cord is
removed from and reconnected to the
wall socket, the demonstration will
remain off until it is switched on again.
To start the demonstration mode
• Press and hold STOP
(on the system
only)
for five seconds when the system
is in standby mode.
™ The demonstration will begin.
CONTROLS OPERATING THE SYSTEM
BACK
REC/CD SYN
PROG / A. REV
FLAT
PRESET
STOP
LOUDNESS
INCREDIBLE
SURROUND
TREBLEBASS
DOLBY B NR
CLOCK/
TIMER
3 CDC
TAPE
CDR/AUX
TUNER
DIGITAL STEREO HIFI SYSTEM
DUBBING
NORMAL•FAST
60Hz 250Hz 500Hz 1KHz 2KHz 4KHz 8KHz SOUND VOLUME
PRESET AM LWTRACK REPEAT MW FM STEREO PROGRAM TIMER SHUFFLE
SURROUND
INCREDIBLE
FLAT
LOUDNESS
CD CHANGER
T.A.
NEWS
SLEEP
DIM
REC
FRONT
HSD
DIM
PLAY
DIGITAL CONTROL
SEARCH/TUNE
PRESET
▲
▲
/
A•B
Notes for remote control:
– First select the source you wish to
control by pressing one of the
source select keys on the remote
control (e.g. CD, TUNER, TAPE 1/2
or AUX).
– Then select the desired function
(
É , í , ë , etc.).
∞ TIMER
– to switch on or off timer.
§ DISPLAY
(not functional for this
model)
≥ B
– to switch the system to standby mode.