EasyManua.ls Logo

Philips OccuSwitch DALI LRM2070 - Technical Data; Environmental Conditions

Philips OccuSwitch DALI LRM2070
15 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
LRM2070, LRM2080, LRM2090 Datasheet
OccuSwitch DALI sensor/controller
14/15
Technical data
Environmental conditions
Storage conditions
Temperature -25 ºC to +85ºC
Relative humidity 10% to 95 %; no condensation
Operating conditions
Temperature +5ºC to +50ºC
Relative humidity 20% to 85%; no condensation
Mains connection
Voltage 230VAC +/10%; 50/60Hz
Power consumption Stand-by <1 W (without DALI
load)
Max. 1.7 W (with 15 drivers)
Connector screw terminal MRT3P5.08-7VE or
MVSTBW 2,5/7-ST-5.08
Wire range 0.75 to 2.5 mm
2
Note wires must be >= 0.75 mm
2
Mains distribution system TN-S, 16A max, with Neutral
grounded
Interfaces
Parallel interface (LRM2080 only) Up to 22 units in parallel
Free topology wiring and polarity
sensitive
BMS interface (LRM2090 only) DALI compatible
Up to 64 units in parallel
(depending on control device
used as master)
Free topology and polarity
insensitive
DALI output interface
Protocol Bi-phase coded according to
EN 60929 Ed 3.0 annex E
Network polarity and polarity
insensitive
Load capacity Maximum 15 DALI devices per
output (for LRM2070 X+DA
Interface)
Protection Interface is short-circuit proof
Transmission rate Max. 1200 bits per second
DALI voltage 11.5VDC to 21.5VDC
Connector type Wieland BST 14i2; blue
General
LED indicators see text
Switch off delay 1,5,10,15,20,25,30,35* minutes
* IRT9090 only
Light levels 250 to 1000 Lux (30% reflection)
Detection range see detection pattern, page 4
Light sensor see diagram, page 4
Standards EN 61347-2-11 Lamp control
gear, Particular requirements for
miscellaneous
electronic circuits used with
luminaires
EN 60598-1 Luminaires, General
requirements and tests
Classification Class I
Pollution degree 2
Over voltage category III
Approbation Product complies with the
relevant European Directive (CE)
ENEC
Protection Class IP20
Flammability UL94 V-0
Glow wire test 960°C/5s
Insulation Supplementary insulation
between Mains and SELV
EMC
Compliance IEC EN 61347-2-11 / EN 60598-1
Immunity IEC EN 61547
Emission IEC EN 55015 and EN 55022,
Class B