Philips PM2519 - 1.7. AC CURRENT MEASUREMENTS; 1.8. RESISTANCE MEASUREMENTS

1-4
1.7.
1.8.
Response time
Protected up to
Max. CM-voltage
Maximum input voltage between
Relative reference setting
AC CURRENT MEASUREMENTS
Ranges
(max. input current in highest range)
Number of representation units
Resolutions
Accuracy
(valid between 3% and 100% of range)
Temperature coefficient
Voltage drop at end of range
AC detector
Crest factor
Response time
Protected up to
Max. input voltage between
Relative reference setting
SMRR
RESISTANCE MEASUREMENTS
Ranges
Resolution
Number of representation units
Accuracy
Temperature coefficient
Measuring current
Maximum voltage at open input
Relative reference setting
Polarity input sockets
:<1s including, < 0.5 s excluding ranging
: 250 mVrms range 20 mA, 200 mA,
Range 2A, 20 A,not protected
max. current 20 A for 20 sec.
: 250 Vrms, 354 Vpeak
: Hl and LO 250 Vrms
HI and earth 250 Vrms
LO and earth 250 Vrms
: With push-button “zero set on/off”
: 20 mA, 200 mA, 2 A, 20A
: 10 A (20 A for max. 20 sec.)
: 2200
: 10 uA in 20 mA range
Measured value less than 20 digits is displayed as 0000
>: 40 Hz... 1kHz:+ (0.8% of reading + 0.1% of full scale)
1kHz... 5kHz:+(5 %of reading + 0.1% of full scale )
2 0.05%/°C
: 20 mA, 2 A range < 60mvV
200 mA range < 300 mV
at10 Aand 20Arange <200mvV
: rms converter
: 9 at full scale; indication ( 4 ) when crest factor exceeded
:<2s including, < 1s excluding ranging
: 250 Vrms range 20 mA, 200 mA.
Range.2 A, 20 A, not protected;
max. current 20 A for 20 sec.
: HI and LO 250 Vrms
HI and earth 250 Vrms
LO and earth 250 Vrms
: With push-button ‘’zero set on/off”
: 14 dB for d.c. signals at full scale
: 1000 Q, 10 kQ, 100 kQ, 1 MQ, 10 MQ
: 100 mQ in 1000 2 range 7
: 11000
: 1000 Q ... 100 kQ + (0.3% of reading + 0.1 of full scale)
1MQ... 10 MQ + (0.5% of reading + 0.1 of full scale)
: 1000 Q, 10 k2, 100 kQ, 1 MQ ranges: + 0,02%/°C
10 MQ. range: + 0.05%/°C
:1mA, 100 uA, 10 uA, 1nA, 100 nA, 10 nA
:3V
: With push-button “‘zero set on/off”
:—onHI
+ontO