Philips PR3120 - Using the Device; Preparing for Use; General Description (Fig. 1)

Voltage dips short interruptions and voltage variations on
power supply input lines IEC61000-4-11
70% 25cycles (50Hz) 30 cycles (60Hz)
Power frequency magnetic field immunity test
IEC61000-4-8
30A/m
Immunity to conducted disturbances, induced by radio
frequency (RF) fields according IEC61000-4-6 in Home
Health Care environments
3 V RMS outside the ISM band, 6 V RMS
inside the ISM and amateur radio bands
(150 kHz – 80MHz)
Radiated RF in Home Health Care environments for 80
MHz – 2.7 GHz according IEC61000-4-3
10V/m
General description (Fig. 1)
1 Timer knob
2 Handgrip
3 Lamp housing
4 Glass plate (filter)
5 Power cord with plug
6 Pedestal
7 Adjustment flap
Preparing for use
Note: Do not suspend the device from a ceiling or hang it on a wall.
1 Fully unwind the power cord.
2 Place the device on a stable, level surface (Fig. 2).
3 Keep at least 25 cm of free space around the device to prevent overheating (Fig. 3).
Using the device
1 Sit or lie down at the right distance from the device.
-
Remove clothing and jewelry from the area to be treated.
-
The infrared light needs to be used on bare skin.
-
At a distance of 30 cm to the body, the device heats an area of about 40 cm by 30 cm (Fig. 5). At a
larger distance, the heated area is larger, but the infrared light and the heat are less intense. At a
smaller distance, the heated area is smaller, but the infrared light and the heat are more intense.
2 Insert the plug into a wall socket.
3 Position the device properly. Below you find some examples.
-
To treat a sore shoulder, a sore neck or part of your upper back area, place the device on a table
and tilt the lamp housing backwards. Sit down on a chair or stool with your back towards the lamp
(Fig. 6).
-
To treat a lower-back ache, place the device on a table beside a chair. Sit down on a chair or stool
with your back towards the lamp (Fig. 7).
-
To treat a sore elbow, place the device on a table and sit down beside it (Fig. 8).
-
To treat a sore knee, place the device on a bedside table. Lie down on the bed with one leg pulled
up towards the lamp (Fig. 9).
4 To switch on the device, turn the timer knob to the desired treatment time (Fig. 10).
-
You can choose a treatment time between 0 and 30 minutes.
11
English