- Do not use the shaver, adapter or any other part if it is damaged, as this
may cause injury. Always replace a damaged adapter, charger or part
with one of the original type.
- Use, charge and store the appliance at a temperature between 10°C
and 35°C.
-
- Only use the adapter, charger and accessories supplied.
- Always put the protection cap on the shaver to prevent damage and to
avoid dirt accumulation in the shaving heads.
Compliance with standards
- The shaver complies with the internationally approved IEC safety
regulations and can be safely cleaned under the tap.
-
(EMF). If handled properly and according to the instructions in this user
General
- The appliance is equipped with an automatic voltage selector and is
suitable for mains voltages ranging from 100 to 240 volts.
- The adapter transforms 100-240 volts to a safe low voltage of less than
24 volts.
Charging
PT866/PT860: It takes approx. 1 hour to fully charge the shaver.
PT736/PT735/PT730/PT725/PT720: It takes approx. 8 hours to fully charge
the shaver.
disuse, let it charge until the charging light lights up continuously.
A fully charged shaver provides up to 50+ shaving minutes for 17 cordless
shaves (PT866/PT860) or up to 40+ shaving minutes for 14 cordless
shaves (PT736/PT735/PT730/PT725/PT720).
The shaving time may be less than 50+ shaving minutes for 17 cordless
shaves (PT866/PT860) or 40+ shaving minutes for 14 cordless shaves
(PT736/PT735/PT730/PT725/PT720) as a result of your shaving behaviour,
your cleaning habits or your beard type.
Charge indications
Battery low
- When the battery is almost empty (when there are only 5 or fewer
-
orange for a few seconds.
Quick charging
- When you start charging the empty battery, the charging light
energy for a 5-minute shave.
ENGLISH 5
To Next Page
Loading...
